|
How To Use Dynax S50
Use a brush, roller or spray to
apply Dynax S50. Atomisation into enclosed cavities and
voids is recommended to ensure thorough coverage of all
surfaces. Dynax-S50 contains highly polar corrosion inhibitors
that are able to displace surface moisture; very wet surfaces
should be pre-treated using Bilt-Hamber Ferrosol.
Dynax S50 injection system
requires no compressor or additional equipment
Dynax S50 is available in 5 litre
tubs to 200 litre drums and upwards for spray application,
for those without access to professional wax injection equipment
Bilt Hamber Laboratories have developed a superb system
enabling Dynax S50 to be applied at high pressure simply,
quickly and without mess. The pressurised giant-sized
Dynax S50 aerosol dispenser accepts interchangeable heads:
The 60cm cavity injection lance has a brass, precision fluid-tip
drilled radially to deliver at high-pressure, a dense, finely
atomised circular mist of Dynax S50 ensuring 3600 coverage
of box sections and cavities. For accessible areas
the extension tube is removed and a solid-cone spray pattern
actuator simply clipped in its place. The pressurised
aerosol dispensers contain a useful 750 ml (3/4 of a litre)
of material.
|
Dynax S50 is tolerant of a broad
range of application pressures and will form a coherent
film upon application. Dynax S50 will increase in viscosity
at low storage temperatures.
It's recommended to place container
in a room at around 15 degrees C for 24 hours prior to use
particularly when using low pressure equipment for spray
application.
For non aerosol-dispensed Dynax
S50 warming the container (loosen cap first) by standing
in a hot water bath will further reduce viscosity and is
beneficial where deep crevice protection is required. Never
heat aerosol dispensed product.Ensure that cavities are
left unclosed for a period of 48 hours to allow the escape
of carrier materials before bunging or stopping.
Dynax S50 will provide excellent
protection at a wide-range of film thickness - aim to achieve
a uniform dry-film thickness of around 50 microns. The tolerance
of the material to maintain protection at very low film
thickness makes Dynax S50 the ideal choice where surface
inspection is not easy or where uniform coatings are simply
not possible.
|
