|
Metal
Ready
|
| |
|
|
|
Rust Remover
& Pre-primer.
|
| |
| Metal Ready is
specifically developed to work in partnership with POR-15
and gives your metal surface ideal surface adhesion. Do
not use other metal prep products since many of them contain
harmful residues which prevent the proper adhesion of POR-15
Rust Prevention paint. Metal ready creates the ideal anchor
pattern for POR-15 and is safe and easy to work with. After
thoroughly degreasing your surface apply Metal Ready to
both neutralise and remove rust. Surface rust removes in
minutes. Allow up to half an hour and repeat if necessary.
Do not leave it on for long periods. Rinse off with water
and allow to completely dry. After drying it will give a
salt and pepper look. This is normal with the Zinc Phosphate
adhering to the metal. |
| |
| It's not necessary
to use if the item has been sand blasted. Metal Ready also
etches new clean bare metal (new metal always has an oil
based preservative on it) and allows for netter adhesion
of POR-15 to any paint coating. It is not caustic, toxic
or flammable. If used in marine application we suggest that
you contact us. |
| |
 |
 |
 |
|
1. Apply metal ready to all metal
areas to be painted |
2. Leave approximately 15 minutes
to remove rust and coat with zinc phosphate
(salt & pepper look) |
3. Rinse with water or wet rag
- surface is now neutralised & coated with zinc
phosphate |
|
| |
| Available in 250ml, 500ml,
1 Litre, 4 Litres. |
| |
|
|
| |
| |
